A 20-year old mystery mechanism influencing DRAM cell retention time fluctuation clarified

Hitachi, Ltd., in cooperation with Elpida Memory announced today that they have identified that the leakage current fluctuation of the p-n junction*1) is the primary factor influencing the charge retention time fluctuation of DRAM cells. As DRAM power consumption is strongly influenced by the retention time, clarifying the mechanism involved is expected to contribute to opening the way for new low power DRAM technology.

Today, DRAM is used as the main memory in high-end servers and PC's, and through the advancement of low power technology, is widening its application to other products such as digital consumer appliances and mobile terminals. A DRAM cell consists of one transistor and one capacitor. A write operation of a DRAM cell is performed by charging the capacitor via an on-state cell transistor, while the cell transistor is in an off-state during the charge retention period. DRAM cell retention time however is limited by charge leakage from the capacitor through an off-state transistor channel and/or a p-n junction. A periodical re-write operation, called a refresh operation, is therefore necessary in DRAM.

In 1987, in relation to DRAM retention time, it was reported that there was an extremely small probability that a DRAM cell with a retention time that fluctuates between two values might exist*2). Although this phenomenon has been known for nearly 20 years, the cause has never been explained. DRAM cells need periodic refresh operations, and to prevent retention failure in all memory cells, a large safety margin accommodating for cell variations in memory retention time is set in current production. In the future, however, as DRAM capacity and integration continue to advance, it will become increasingly difficult to maintain a large safety margin, making it more difficult to achieve stable low-power operation. Thus, clarifying the mechanism behind memory retention time fluctuations was considered an essential step in the development of large capacity highly integrated DRAM.

In response to these issues, Hitachi and Elpida focused on the leakage current of cell transistors as the cause of retention time fluctuation, and used test devices to conduct detailed measurements. Below are three main findings:

(1) Cell transistors with a reversible leakage current fluctuating between two values, exist at a ratio of a few transistors per 10,000 transistors.
(2) The leakage current in the DRAM cell consists of a channel leakage of the cell transistor and a p-n junction leakage, however, the reversible fluctuation only occurs in the case of the p-n junction
(3) The p-n junction leak current fluctuation has a large temperature dependence; easily fluctuating at high temperatures, increasing the frequency of fluctuations between the two values.

Usually, point defects in the depletion layer of a p-n junction increase the leakage-current of the p-n junction. Thus the mechanism generating the reversible fluctuation of p-n junction leakage-current between two values is thought to be the result of a point defect having two different energy levels,*3) and alternating between them. From the thermal characteristic measurements of (3), it was possible to calculate the energy required for transition between the two states, which was found to be approximately 1 eV (electron volt). This value is comparable to the energy reported in the case of DRAM retention time fluctuation. As a result, it became clear that the direct cause of the reversible fluctuations in retention time can be found in the reversible fluctuations of the p-n junction leakage current.

This study has contributed to the fundamental understanding of memory cell retention performance, which will have a large impact on the continuation of large capacity, highly integrated, low power DRAM development.

These results presented at the 2005 IEEE International Electron Devices Meeting, held in Washington, D.C., U.S.A., from 5th - 7th December 2005.

Notes:

*1) A p-n junction is a junction of p-type and n-type semiconductors, which is a basic component of semiconductor devices. A main electrical property of the p-n junction is a rectification: current flows through the p-n junction under forward bias condition, while a current does not flow under reverse bias condition. The p-n junction is also part of an MOS transistor. The p-n junction as mentioned here is a part of DRAM cell transistor.
*2) Reported by IBM at IEDM 1987.
*3) Energy levels: A free electron in a semiconductor crystal can takes any kinetic energy depending on its speed, except in the forbidden band. The forbidden band is an energy region created by the periodicity of the atomic configuration of the semiconductor crystal, which the electron cannot take. When a point defect or contamination occurs, this periodicity is broken, and an energy level is created within the forbidden band. This energy level facilitates charge flow through the p-n junction, contributing to p-n junction leakage.

Source: Hitachi Ltd.

Related stories:

Elpida Verifies the Physical Phenomena of Defect Repair Technology on a Microscopic Level
Elpida Memory announced recently that it has successfully developed defect repair technology that leads to dramatic improvement of data retention, and has also identified the physical phenomena that dominate DRAM retention characteristics by applying a technique known as electrically detected magnetic resonance (EDMR) for the first time. This research and development was done in conjunction with NEC Corporation's System Devices Research Laboratories, and the University of Tsukuba.
Infineon Achieves Breakthrough in DRAM Trench Technology
Infineon Technologies AG presented a highly manufacturable 70nm process technology for future DRAM generations that is based on deep trench (DT) cells on 300mm wafers at the 2004 IEEE International Electron Devices Meeting (IEDM) in San Francisco (December 13 - 15, 2004). Around 25 per cent of the worldwide DRAM production today is based on trench technology. In the paper, Infineon shows the full integration scheme and the major technology features which include for the first time high-k dielectric material in a trench based DRAM manufacturing process. The results of the Infineon 70nm DRAM program represent a technological breakthrough and show the scalability of trench technology.

Nanoscale computer memory retrieves data 1,000 times faster
Scientists from the University of Pennsylvania have developed nanowires capable of storing computer data for 100,000 years and retrieving that data a thousand times faster than existing portable memory devices such as Flash memory and micro-drives, all using less power and space than current memory technologies.
TSMC Manufactures First Functional 65nm Embedded DRAM Device
Taiwan Semiconductor Manufacturing Company, Ltd. today announced the foundry industry’s first functional 65nm embedded DRAM customer product. The product contains millions of DRAM bits and was silicon verified first time right.
NEC Electronics Introduces Industry's First Ultra-Low-Power 55-nanometer Embedded DRAM Technology
NEC Electronics today announced the industry's first 55- nanometer CMOS-compatible embedded DRAM (eDRAM) technology, UX7LSeD.
0.4-V DRAM array technology using twin cells for next generation mobile devices
Enabling the longer retention time and fast read/write operation under low voltage condition

Hitachi, Ltd. in cooperation with Elpida Memory, Inc., have proposed a new DRAM (*1) circuit design enabling 0.4-V operation. The proposed array employs a twin cell scheme, which uses two conventional DRAM cells to store 1-bit information, and achieves a longer retention time and fast read/write operation under low voltage condition. This technology will be fundamental for designing DRAM, with its large memory capacity, as the low power memory device in next generation mobile information devices.
Elpida Memory Develops Distortion Control Technology to Improve Mass Production of Highly-Reliable DRAM
Elpida Memory, Inc., Japan's leading global supplier of Dynamic Random Access Memory (DRAM), today announced that it has developed a new distortion control technology that improves data retentiveness-an element that is crucial for obtaining high yields of high-performance DRAM products during the mass production phase. The technology was developed in partnership with NEC Corporation System Devices Research Laboratory. The technology also allows volume-produced DRAM to achieve the higher performance necessary for future applications while remaining cost-competitive. These achievements were presented at the 2004 International Electron Devices Meeting (IEDM) held in San Francisco on December 13-15, 2004.
Toshiba and NEC Develop Key Technologies for High-Density MRAM
Toshiba Corporation and NEC Corporation today announced two key advancements toward development of a magnetoresistive random access memory, a technology seen as key to the development of future generations of high performance mobile equipment. Unveiling the latest fruits of a joint development program dating back to 2002, the two companies announced a new cell design that halves power consumption during data writes and cuts writing errors, and a novel MRAM architecture with high speed characteristics and a performance that will support development of high-density devices.

News discussion:

Physics news