Firearms Microstamping Feasible but Variable, Study Finds

New technology to link cartridge cases to guns by engraving microscopic codes on the firing pin is feasible, but did not work equally well for all guns and ammunition tested in a pilot study by researchers from the forensic science program at the University of California, Davis. More testing in a wider range of firearms is needed, the researchers said.

Microstamping technology uses a laser to cut a pattern or code into the head of a firing pin or another internal surface. The method is similar to that used to engrave codes on computer chips. When the trigger is pulled, the firing pin hits the cartridge case or primer and stamps the code onto it. In principle, the spent cartridge can then be matched to a specific gun.

In October 2007, Gov. Arnold Schwarzenegger signed into law AB 1471, requiring that all new models of semiautomatic pistols sold in California on or after Jan. 1, 2010, be engraved in two or more places with an identifying code that is transferred to the cartridge case on firing. Similar legislation has been proposed in other states and at the federal level.

In March 2008, a report from the National Research Council, part of the National Academies of Science, described microstamping as a "promising" approach and called for more in-depth studies on the durability of microstamped marks under different firing conditions.

"Our study confirms the NRC position that more research should be conducted on this technology," said Fred Tulleners, director of the forensic science graduate program at UC Davis. Tulleners is former director of the California Department of Justice crime labs in Sacramento and Santa Rosa.

If successfully implemented, microstamping would be one additional piece of evidence for investigators to link various shooting events, Tulleners said.

UC Davis graduate student Michael Beddow looked at the performance of microstamped marks in one location, the firing pin. He tested firing pins from six different brands of semi-automatic handguns, two semi-automatic rifles and a shotgun. The firing pins were engraved with three different types of code: a letter/number code on the face of the firing pin; a pattern of dots or gears around the pin; and a radial bar code down the side of the pin. The engraved firing pins were purchased from ID Dynamics of Londonderry, N.H.

To test the effects of repeated firing, Beddow fitted engraved firing pins into six Smith and Wesson .40-caliber handguns that were issued to California Highway Patrol cadets for use in weapons training. After firing about 2,500 rounds, the letter/number codes on the face of the firing pins were still legible with some signs of wear. But the bar codes and dot codes around the edge of the pins were badly worn.

"They were hammered flat," Beddow said.

Tests on other guns, including .22-, .380- and .40-caliber handguns, two semi-automatic rifles and a pump-action shotgun, showed a wide range of results depending on the weapon, the ammunition used and the type of code examined, Beddow found. Generally, the letter/number codes on the face of the firing pin and the gear codes transferred well to cartridge cases, but the bar codes on the sides of the firing pin performed more poorly. Microstamping worked particularly poorly for the one rimfire handgun tested.

The researchers did not have access to patented information allowing them to read the bar- or gear-codes, and so could not determine if these remained legible enough to be useful.

Codes engraved on the face of the firing pin could easily be removed with household tools, Beddow found.

The researchers estimated that setting up a facility to engrave alphanumeric codes on firing pins would cost about $7 to $8 per firing pin in the first year, assuming that such marks would be required on all handguns sold in California, and based on the efficiencies associated with high-volume production costs, Tulleners said.

Tulleners said that a larger test of about 3,000 firing pins, from a wider range of guns, would allow for a more "real-world" test of the technology, as called for by the National Research Council report. About 2,000 makes and models of handguns are sold in California, compared with the nine tested, Beddow estimated in the study. A larger study would also help show how useful this technology might be in detecting and preventing crime.

AB1471 also requires at least one other internal location for microstamping a number. Microstamping on areas other than the firing pin was not tested in this study. Based on the study's preliminary results with a .22-caliber pistol, where the code on the firing pin was transferred to the brass of the cartridge rather than the softer primer, the effectiveness of such a requirement needs further assessment, Tulleners said.

David Howitt, professor of chemical engineering and materials science at UC Davis, supervised the project.

The study was funded by a grant from the California Policy Research Center, part of the University of California Office of the President. The report has completed peer review by experts selected by the center, and a paper describing the results has been accepted and scheduled for publication in an upcoming issue of the Association of Firearm and Toolmark Examiners (AFTE) Journal.

Source: UC Davis

Related stories:

Microstamping Guns Feasible but Flawed, Study Finds
New technology to link cartridge cases to guns by engraving microscopic codes on the firing pin is feasible, but does not work well for all guns and ammunition tested in a pilot study by researchers from the forensic science program at UC Davis. More testing in a wider range of firearms is needed to determine the costs and feasibility of a statewide program of microstamping, as called for by proposed state legislation, the researchers said.
When a light goes on during thought processes
(PhysOrg.com) -- Thought processes made visible: An international team of scientists headed by Mazahir Hasan of the Max Planck Institute for Medical Research in Heidelberg has succeeded in optically detecting individual action potentials in the brains of living animals. The scientists introduced fluorescent indicator proteins into the brain cells of mice via viral gene vectors: the illumination of the fluorescent proteins indicates both when and which neurons are communicating with each other.
Simple and secure networked home
(PhysOrg.com) -- Most people will only start to control equipment remotely in their homes when they believe it is simple and safe to do so. A newly developed control system provides personalised answers.
Pulsing light silences overactive neurons
Scientists at the MIT Media Lab have invented a way to reversibly silence brain cells using pulses of yellow light, offering the prospect of controlling the haywire neuron activity that occurs in diseases such as epilepsy and Parkinson's disease.
Two Brains - One Thought
Although no two brains are alike, they can display a comparable pattern of neural activity when exposed to similar sensory input. Scientists at the Max Planck Institute for Dynamics and Self-Organization in Göttingen have now developed a mathematical method to design networks from neural cells which exhibit a predefined pattern dynamics. The researchers hope that their method will assist them in getting closer to understanding which of the possible network configurations was privileged by evolution - and why (Physica D: Nonlinear Phenomena, December, 2006).
NIST 'Standard Bullet' fights gang violence
Researchers at the National Institute of Standards and Technology (NIST) have developed a copper bullet designed to help end criminal sprees without once being fired. Crime laboratories can use NIST's "Standard Bullet" to optimize the settings of computerized optical imaging instruments used to match markings on fired bullets from a suspected weapon.
Study Defines RFID System Capacity, Sets Performance Metrics for Gen-2 Protocol
Engineering researchers at the University of Arkansas have developed a novel mathematical model that describes how radio-frequency-identification (RFID) readers capture tag data on a single inquiry. The researchers – Kazem Sohraby, professor of electrical engineering, and Chonggang Wang, post-doctoral fellow in the department of electrical engineering – also developed two critical performance metrics to measure capacity of a single RFID reader environment.
Phase diagram of water revised
Supercomputer simulations by two Sandia researchers have significantly altered the theoretical diagram universally used by scientists to understand the characteristics of water at extreme temperatures and pressures.

News discussion:

General Science news