Fujitsu Develops Technology for Low-Power, High-Performance 45nm Logic Chips

Fujitsu today announced the development of a platform technology for 45 nanometer generation LSI logic chips, which combines technologies for low power consumption and high-performance interconnect.

Compared to previous 45nm technologies on record, the new platform reduces the leakage current that occurs when current is wasted in wait states to one-fifth that of previous levels and reduces interconnect-induced lag times by approximately 14%. The realization of these new 45nm generation platform technologies will enable Fujitsu to offer its customers LSI logic chips that feature even higher speeds, smaller size and lower power consumption than currently available.

Details of the new technology were presented at the 2007 Symposium on VLSI Technology.

The need to achieve higher levels of integration in LSI logic chips is becoming greater, spurred by the higher level of performance needed to support the proliferation of functions in various devices, and the need for multiple processor cores on devices. In light of these trends, for 45nm generation logic technology, in accordance with higher integration levels and enhancements in performance speeds, technologies able to suppress power consumption of devices are becoming increasingly important.

In order to heighten integration levels of LSIs, with each new generation of devices, there is a need to shorten the gate length of each transistor and make the spaces between interconnects narrower. In addition, to achieve high speeds there is a need to minimize the time lag from interconnects between the hundreds of millions of individual transistors within the LSI chip.

When a the gate length of a transistor is shortened, a problem that exists is increased power consumption attributable to increased leakage current between the transistor's source and drain when no signal voltage is applied at the gate - for example, when a mobile phone is on standby mode awaiting calls and no operation processing is underway.

For the 45nm generation, both the width of interconnects and the spaces between interconnects, are at the smallest 65nm. In addition to an increase of interconnect resistance due to miniaturization, if the insulating layer's dielectric constant stays the same as the previous generation, interconnect capacitance will increase, thereby resulting in increased interconnect lag and thus necessitating a material with lower dielectric constant.

Fujitsu's New Technology

1. New annealing technology

Fujitsu researchers found that forming shallower source and drain regions is an effective way to reduce leakage current (Figure 2). However, simply making them shallower also increases resistance at the source and drain regions, thereby degrading transistor performance. To counteract this, Fujitsu researchers developed a new annealing technology called millisecond annealing (MSA). Compared to previous annealing, Fujitsu's millisecond annealing technology uses higher temperatures thus enabling reduction of resistance, and because the annealing time is brief it possible to form shallow sources and drain regions and thereby reduce leakage current.

2. High-performance interconnects

Fujitsu researchers used nano-clustering silica (NCS), which has a dielectric constant (k) of 2.25 - the lowest of any insulating film reported to date - in a lower interconnect region suitable for the smallest interconnect spaces.

NCS is an insulating material pocked with miniscule holes, enabling both a low dielectric value and high mechanical strength simultaneously. Fujitsu introduced NCS on a partial basis beginning with the 65nm generation. However, for the 45nm generation, the company is using NCS not just within a given interconnect layer but also between different layers to further reduce interconnect capacitance.

The new annealing technique is highly effective in limiting transistor resistance, reducing leakage current to one-fifth that of previous levels, thereby enabling advantages such as extending mobile phone maximum standby (wait) time up to five-fold.

In addition, by utilizing high-performance interconnect technology Fujitsu was able to achieve a 14% reduction in interconnect lag time in comparison to standard 45nm generation interconnect technologies in the International Technology Roadmap for Semiconductors.

These two newly developed technologies enable the reduction of leakage current during standby, while simultaneously increasing operating speed. Fujitsu is targeting 2008 to incorporate these technologies into LSIs that are suited for mobile devices as part of a ubiquitous networking society.

Source: Fujitsu

Related stories:

Intel Demonstrates Industry's First 32nm Chip and Next-Generation Nehalem Microprocessor Architecture
Intel Corporation President and CEO Paul Otellini today outlined new products, chip designs and manufacturing technologies that will enable the company to continue its quickened pace of product and technology leadership.
AMD Demonstrates First Graphics Processors to Feature Native DisplayPort 1.1
AMD has successfully tested a next-generation graphics processor with a native DisplayPort 1.1 transmitter.
The original nano workout -- Helping carbon nanotubes get into shape
Researchers at Rensselaer Polytechnic Institute have developed a new method of compacting carbon nanotubes into dense bundles. These tightly packed bundles are efficient conductors and could one day replace copper as the primary interconnects used on computer chips and even hasten the transition to next-generation 3-D stacked chips.
AMD's Next-Gen Mobile Chip, Platform to Conserve Power
Advanced Micro Devices hopes to have its next-generation mobile microprocessor and platform in the hands of OEMs by the middle of 2008.


Inexpensive 'nanoglue' can bond nearly anything together
Researchers at Rensselaer Polytechnic Institute have developed a new method to bond materials that don’t normally stick together. The team’s adhesive, which is based on self-assembling nanoscale chains, could impact everything from next-generation computer chip manufacturing to energy production.
Samsung Electronics Develops New, Highly Efficient Stacking Process for DRAM
Samsung Electronics today announced that it has developed the first all-DRAM stacked memory package using 'through silicon via' (TSV) technology, which will soon result in memory packages that are faster, smaller and consume less power.
HP Unveils New Data Warehouse, BI Services
The new storage and business intelligence system, designed for Global 2000 companies, features high-performance analytics and high-capacity storage.
Samsung Develops New, Highly Efficient Stacking Process for DRAM
Samsung Electronics today announced that it has developed the first all-DRAM stacked memory package using ‘through silicon via’ (TSV) technology, which will soon result in memory packages that are faster, smaller and consume less power.

News discussion:

Technology news