Jules Verne on track for long journey to ISS

Following an overnight recovery operation, Jules Verne ATV's propulsion system has successfully been restored to full robustness. The spacecraft has since performed the first orbital manoeuvres necessary to set up phasing with the International Space Station.

Flight control and engineering support teams analysed the data coming from the Automated Transfer Vehicle's on board computers which, after activation of the propulsion system following Sunday's launch, had detected a significant difference in pressure between the oxidiser and the fuel that compose the propellant and had disabled part of the propulsion system. A course of action was implemented overnight to resume the nominal mission.

In a complex operation, commands to re-integrate an electronics box which drives that part of the propulsion system were up-linked to the spacecraft from within the ATV Control Centre in Toulouse, France. After the entire propulsion system was disabled, all four propulsion chains were progressively enabled, thereby restoring full failure tolerance.

Jules Verne ATV successfully performed a series of orbital manoeuvres earlier this afternoon. The two manoeuvres using the main engines, which occurred at 15:54 CET (14:54 UT) and 17:06 CET (16:06 UT), initiated the orbital phasing. Two additional orbit manoeuvres tomorrow afternoon will complete the phasing boost.

Mission controllers in Toulouse are now rescheduling activities to take Jules Verne ATV to its parking orbit in front of the ISS, including a demonstration of the spacecraft's Collision Avoidance Manoeuvre capability. Once in the parking orbit, Jules Verne ATV will wait for the completion of the STS-123 Shuttle mission at the Space Station, before proceeding with the rendezvous demonstration manoeuvres and the final rendezvous and docking.

Jules Verne ATV remains on schedule for docking with the ISS on 3 April.

Jules Verne ATV successfully performed a series of orbital manoeuvres earlier this afternoon. The two manoeuvres using the main engines, which occurred at 15:54 CET (14:54 UT) and 17:06 CET (16:06 UT), initiated the orbital phasing. Two additional orbit manoeuvres tomorrow afternoon will complete the phasing boost.

Mission controllers in Toulouse are now rescheduling activities to take Jules Verne ATV to its parking orbit in front of the ISS, including a demonstration of the spacecraft's Collision Avoidance Manoeuvre capability. Once in the parking orbit, Jules Verne ATV will wait for the completion of the STS-123 Shuttle mission at the Space Station, before proceeding with the rendezvous demonstration manoeuvres and the final rendezvous and docking.

Jules Verne ATV remains on schedule for docking with the ISS on 3 April.

Source: ESA

Related stories:

Jules Verne boosts ISS orbit
ESA's Jules Verne ATV was used for the first time early this morning to raise the orbit of the International Space Station. A 740-second burn of the Automated Transfer Vehicle's main engines successfully lifted the altitude of the 280-tonne Station by around 4.5 km to a height of 342 km above the Earth's surface.
ATV Jules Verne automated ship docks to the ISS
ATV Jules Verne, the European Space Agency’s first resupply and reboost vehicle, has successfully performed a fully automated docking with the International Space Station (ISS). This docking marks the beginning of Jules Verne’s main servicing mission to deliver cargo, propellant, water, oxygen and propulsion capacity to the Station, as well as ESA’s entry into the restricted club of the partners able to access the orbital facility by their own means.
Jules Verne ATV given 'go' for docking
Jules Verne was today formally cleared to proceed with the first ISS docking attempt, scheduled for 3 April 2008 at 16:41 CEST (14:41 UT). The official go-ahead came from the International Space Station Mission Management Team (IMMT) after two flawless demonstration days in which Jules Verne proved its operational capabilities.
Impressive dress-rehearsal for Jules Verne ATV
Jules Verne ATV today approached the International Space Station to within 11 m of the docking port on the Russian Zvezda module. The approach was part of a second ATV demonstration day which clears the way for the first rendezvous and docking attempt on 3 April.
Follow live Jules Verne ATV's first attempt to dock with the International Space Station
After several days spent in a parking orbit 2000 km ahead of the ISS, Jules Verne ATV is now ready to join up with the International Space Station. This first docking attempt can be followed live on 3 April 2008 from 15:30 CEST onwards from one of the European participating centres.
Jules Verne reaches 'parking' orbit
Jules Verne ATV has today reached a parking position 2000 km ahead of the International Space Station. Europe's ISS re-supply spacecraft will wait at this holding point for the completion of the STS-123 Space Shuttle mission before proceeding with the first of two rendezvous demonstration days.
Successful manoeuvres position Jules Verne ATV for crucial tests
Jules Verne ATV successfully performed two boosts today, bringing the spacecraft to an altitude of 303 km – half-way between the insertion orbit reached after last Sunday's launch and the orbit of the International Space Station.
Jules Verne ATV launch approaching
After the successful launch of ESA’s Columbus laboratory aboard Space Shuttle Atlantis on Thursday (7 February), it is now time to focus on the next imminent milestone for ESA: the launch of Jules Verne, the first Automated Transfer Vehicle (ATV) to be sent to the International Space Station.

News discussion:

Space & Earth science news