Toshiba Corporation today announced that it has developed a new double tunneling layer technology applicable to future 10nm generation flash memories.
This elemental technology opens the way for memory devices with densities of over 100 gigabits in the 10nm generation, which lies four generations ahead. The technology was today announced at the IEDM (International Electron Devices Meeting) held at Washington D.C., U.S.A.
Toshiba developed a tunnel layer, which controls in and out of electron, in the SONOS (Silicon Oxide Nitride Oxide Semiconductor) type device structure, a memory structure that holds electrons in the nitride layer in the gate insulator.
The new structure sandwiches a 1.2 nm silicon nanocrystals layer between the 1nm thickness oxide films, achieving long-time data retention and high speed writing and data deletion at the same time, using the natural characteristic that resistance changes with changes in gate voltage. As the new tunnel layers are thinner than early version SONOS element tunnel layers, it is easier to migrate to advanced devices with finer lithography.
Toshiba also increased the saved electrons amount by changing the nitride film from Si3N4 to Si9N10, a material that contains more silicon, and optimized such aspects of the element structure as channel impurity concentration. The prototype has realized and maintained equivalent to over 10 years performance.
Toshiba is investigating various technologies for future advanced memories, including 3D structures, and believes that realizing operation in the 10nm generation with its new double tunneling layer technology is a step forward to future practical devices.
Source: Toshiba
Related stories:
Bottoms up: Better organic semiconductors for printable electronics
Researchers from the National Institute of Standards and Technology and Seoul National University have learned how to tweak a new class of polymer-based semiconductors to better control the location and alignment of the components of the blend. Their recent results—how to move the top to the bottom—could enable the design of practical, large-scale manufacturing techniques for a wide range of printable, flexible electronic displays and other devices.
Invisibility undone: Chinese scientists demonstrate how to uncloak an invisible object
Harry Potter beware! A team of Chinese scientists has developed a way to unmask your invisibility cloak. According to a new paper in the latest issue of
Optics Express, the Optical Society's (OSA) open-access journal, certain materials underneath an invisibility cloak would allow invisible objects be seen again.
A first in integrated nanowire sensor circuitry
Scientists at the U.S. Department of Energy's Lawrence Berkeley National Laboratory and the University of California at Berkeley have created the world's first all-integrated sensor circuit based on nanowire arrays, combining light sensors and electronics made of different crystalline materials. Their method can be used to reproduce numerous such devices with high uniformity.
Bioengineers develop 'microscope on a chip'
Researchers at the California Institute of Technology have turned science fiction into reality with their development of a super-compact high-resolution microscope, small enough to fit on a finger tip. This "microscopic microscope" operates without lenses but has the magnifying power of a top-quality optical microscope, can be used in the field to analyze blood samples for malaria or check water supplies for giardia and other pathogens, and can be mass-produced for around $10.
Advance brings low-cost, bright LED lighting closer to reality
Researchers at Purdue University have overcome a major obstacle in reducing the cost of "solid state lighting," a technology that could cut electricity consumption by 10 percent if widely adopted.
Freeing light shines promise on energy-efficient lighting
(PhysOrg.com) -- The latest bright idea in energy-efficient lighting for homes and offices uses big science in nano-small packages to dim the future Edison's light bulb.
Beyond 3G, communications services of the future
(PhysOrg.com) -- Europe's telecommunications industry became the world leader in the 1990s. Now European researchers are working to maintain that lead by developing an innovative services platform for 'Beyond 3G' communications.
Research helps understand factors that influence efficiency of organic-based devices
Organic-based devices, such as organic light-emitting diodes, require a transparent conductive layer with a high work function, meaning it promotes injection of electron holes into an organic layer to produce more light.