Traces of nanobubbles determine nano-boiling

Using a microscope and some extreme “snapshot” photography with shutter speeds only a few nanoseconds long, researchers from the National Institute of Standards and Technology and Cornell University have uncovered the traces of ephemeral “nanobubbles” formed in boiling water on a microheater. Their observations suggest an added complexity to the everyday phenomenon of boiling, and may affect technologies as diverse as inkjet printers and some proposed cancer therapies.

You might think that the science of boiling had been worked out some time ago, but it still has some mysteries, particularly at the nanometer scale. As water and other fluids change from their liquid state to a vapor, bubbles of the vapor form. The bubbles usually form at “nucleation sites,” which can be small surface irregularities on the container or tiny suspended particles in the fluid. The exact onset of boiling depends on the presence and nature of these sites.

To observe the process, the NIST/Cornell team used a unique ultrafast laser strobe microscopy technique with an effective shutter speed of eight nanoseconds to photograph bubbles growing on a microheater surface about 15 micrometers wide. At this scale, a voltage pulse of only five microseconds superheats the water to nearly 300 °C, creating a microbubble tens of microns in diameter. When the pulse ends, the microbubble collapses as the water cools.

What the team found was that if a second voltage pulse follows closely enough, the second microbubble forms earlier during the pulse and at a lower temperature apparently, as conjectured by the team, because nanobubbles formed by the collapse of the first bubble become new nucleation sites for the growth of later bubbles. The nanobubbles themselves are too small to observe, but by changing the timing between voltage pulses and observing how long it takes the second microbubble to form, the researchers were able to estimate the lifetime of the nanobubbles—roughly 100 microseconds.

These experiments are believed to be the first evidence that nanoscale bubbles can form on hydrophilic surfaces (previous evidence of nanobubbles was found only for hydrophobic surfaces like oilcloth) and the method for measuring nanobubble lifetimes may improve models for optimal heat transfer design in nanostructures. The work has immediate implications for inkjet printing, in which a metal film is heated with a voltage pulse to create a bubble that is used to eject a droplet of ink through a nozzle. If inkjet printing is pushed to higher speeds (repetition rates above about 10 kilohertz), the work suggests, nanobubbles on the heater surface between pulses will make it difficult or impossible to control bubble formation properly.

The findings also may impact proposed thermal cancer therapies in which nanoscale objects are designed to accumulate in tumors and are subsequently heated remotely by infrared radiation or alternating magnetic fields. Each particle acts as a nanoscale heater, with nanobubbles being created if the applied radiation is sufficient. The bubbles may have a therapeutic effect through additional heat delivered and mechanical stresses they may impart to the surrounding tissue.

Citation: R. E. Cavicchi and C.T. Avedisian. Bubble nucleation and growth anomaly for a hydrophilic microheater attributed to metastable nanobubbles. Phys. Rev. Lett. 98, 124501 (2007).

Source: National Institute of Standards and Technology

Related stories:

Blowing bubbles on a nanoscale
(PhysOrg.com) -- Scientists are puzzled by the nanobubbles that can develop on surfaces under water. It should be impossible for them to exist but nevertheless they remain intact for hours. They are something of a mystery, yet it is possible to manipulate the development of these bubbles, according to PhD candidate Shangjiong Yang at the University of Twente, Netherlands. The bubbles can then, for example, be used to reduce flow resistance in liquids. Yang received his doctorate from the Faculty of Applied Sciences on 9 October.
New nano technique significantly boosts boiling efficiency
Whoever penned the old adage "a watched pot never boils" surely never tried to heat up water in a pot lined with copper nanorods.
Nanobubbles Deliver Targeted Cancer Drugs Using Ultrasound
A new targeted drug delivery method uses ultrasound to image tumors, while also releasing the drug from "nanobubbles" into the tumor.
Nanobubbles exist, and are more stable than previously thought
When William Ducker, a professor at the University of Melbourne in Australia started experiments on so-called nanobubbles that form as a gas state on the boundary between liquid and gas, he fully expected to discover two things: 1) that the nanobubbles didn’t exist, and 2) that if they did, they would be unstable, existing for no more than a second. So it came as a surprise when the results of an experiment he performed along with Xuehua Zhang, required Ducker to admit that he was wrong. “Not only do these nanobubbles exist, but they are relatively stable, lasting for days,” he tells PhysOrg.com.
Water theory is watertight, researchers say
There may be tiny bubbles in the wine, but not at the interface between water and a waxy coating on glass, a new study shows.
Tiny Bubbles in Nanofilms
A group of theoretical physicists at the University of Arkansas has demonstrated that under applied voltages, thin films composed of technologically important ferroelectric materials form "nanobubbles," which have the potential to become a way to store lots of information in a tiny space. This could impact technologies from computers and portable electronics such as cell phones and MP3 players, to radio frequency identification devices.

News discussion:

Nanotechnology news