Nanotechnology is paving the way toward improved solar cells. New research shows that a film of carbon nanotubes may be able to replace two of the layers normally used in a solar cell, with improved performance at a lower cost. Researchers have found a surprising way to give the nanotubes the properties they need: add defects.
Currently, these solar cells, called dye-sensitized solar cells, have a transparent film made of an oxide that is applied to glass and conducts electricity. In addition, a separate film made of platinum acts as a catalyst to speed the chemical reactions involved.
Both of these materials have disadvantages, though. The oxide films can't easily be applied to flexible materials: they perform much better on a rigid and heat resistant substrate like glass. This increases costs and limits the kinds of products that can be made. And expensive equipment is necessary to create the platinum films.
Jessika Trancik of the Santa Fe Institute, Scott Calabrese Barton of Michigan State University and James Hone of Columbia University decided to use carbon nanotubes to create a single layer that could perform the functions of both the oxide and platinum layers. They needed it to have three properties: transparency, conductivity, and catalytic activity.
Ordinary carbon nanotubes films are so-so in each of these properties. The obvious ways of improving one, though, sacrifice one of the others. For example, making the film thicker makes it a better catalyst, but then it's less transparent.
Previous theory had suggested that materials may function better as catalysts when they have tiny defects, providing sites for chemicals to attach. So the researchers tried exposing the carbon nanotubes to ozone, which roughs them up a bit. Very thin films, they found, became dramatically better catalysts, with more than ten-fold improvement.
In order to address the trade-off between transparency and conductivity, the researchers tried another trick on a bottom layer of tubes: they created carbon nanotubes that were longer. This improved both conductivity and transparency.
The carbon nanotube films might be used in fuel cells and batteries as well.
"This study is an example of using nanostructuring of materials – changing things like defect density and tube length at very small scales – to shift trade-offs between materials properties and get more performance out of a given material," Trancik says. "Making inexpensive materials behave in advanced ways is critical for achieving low-carbon emissions and low cost energy technologies."
The researchers published their results recently in Nano Letters. They are currently in the process of filing a patent application for their techniques.
Source: Santa Fe Institute
Related stories:
New study on properties of carbon nanotubes, water could have wide-ranging implications
A fresh discovery about the way water behaves inside carbon nanotubes could have implications in fields ranging from the function of ultra-tiny high-tech devices to scientists' understanding of biological processes, according to researchers from the University of North Carolina at Chapel Hill.
Nanoscale carbon materials research wins the 2008 Julius Springer Prize for Applied Physics
Dr. Phaedon Avouris of IBM and Professor Tony Heinz of Columbia University were presented with the 2008 Julius Springer Prize for Applied Physics on 27 September 2008 during a day-long forum at Harvard University, attended by luminaries of the field. The Julius Springer Prize for Applied Physics recognizes researchers who have made an outstanding and innovative contribution to the field of applied physics. The forum was sponsored by the scientific publisher Springer.
Breakthrough for carbon nanotube materials
(PhysOrg.com) -- In collaboration with scientists from the NanoTech Institute of the University of Texas at Dallas (UTD) – CSIRO has achieved a major breakthrough in the development of a commercially-viable manufacturing process for a range of materials made from carbon nanotubes.
Carbon nanostructures form the future of electronics and optoelectronics
This year's Julius Springer Prize for Applied Physics will be awarded to Phaedon Avouris and Tony Heinz for their pioneering work on the electrical and optical properties of nanoscale carbon materials including carbon nanotubes − from basic science to exciting applications. The award, accompanied by US$ 5,000, will be presented at the Julius Springer Forum on Applied Physics 2008 at Harvard University in Cambridge, MA, on 27 September 2008.
'Buckyballs' have high potential to accumulate in living tissue
Research at Purdue University suggests synthetic carbon molecules called fullerenes, or buckyballs, have a high potential of being accumulated in animal tissue, but the molecules also appear to break down in sunlight, perhaps reducing their possible environmental dangers.
Flower-shaped nanoparticles may lead to better batteries for portable electronics
Want more power and longer battery life for that cell phone, laptop, and digital music player? "Flower power" may be the solution. Chemists are reporting development of flower-shaped nanoparticles with superior electronic performance than conventional battery materials. These "nanoflowers" may power next-generation electronic devices, say the scientists in a report scheduled for the Oct. 8 issue of ACS'
Nano Letters.
Water purification down the nanotubes
Nanotechnology could be the answer to ensuring a safe supply of drinking water for regions of the world stricken by periodic drought or where water contamination is rife. Writing in the
International Journal of Nuclear Desalination, researchers in India explain how carbon nanotubes could replace conventional materials in water-purification systems.
True properties of carbon nanotubes measured
For more than 15 years, carbon nanotubes (CNTs) have been the flagship material of nanotechnology. Researchers have conceived applications for nanotubes ranging from microelectronic devices to cancer therapy. Their atomic structure should, in theory, give them mechanical and electrical properties far superior to most common materials.