Engineers and researchers designing and building new microelectromechanical systems (MEMS) can benefit from a new test method developed at the National Institute of Standards and Technology to measure a key mechanical property of such systems: elasticity. The new method determines the “Young’s modulus” of thin films not only for MEMS devices but also for semiconductor devices in integrated circuits.
Since 1727, scientists and engineers have used Young’s modulus as a measure of the stiffness of a given material. Defined as the ratio of stress (such as the force per unit area pushing on both ends of a beam) to strain (the amount the beam is deflected), Young’s modulus allows the behavior of a material under load to be calculated.
Young’s modulus predicts the length a wire will stretch under tension or the amount of compression that will buckle a thin film. A standard method to determine this important parameter—a necessity to ensure that measurements of Young’s modulus made at different locations are comparable—has eluded those who design, manufacture and test MEMS devices, particularly in the semiconductor industry.
A team at NIST recently led the effort to develop SEMI Standard MS4-1107, “Test Method for Young’s Modulus Measurements of Thin, Reflecting Films Based on the Frequency of Beams in Resonance.” The new standard applies to thin films (such as those found in MEMS materials) that can be imaged using an optical vibrometer or comparable instrument for non-contact measurements of surface motion.
In particular, measurements are obtained from resonating beams—comprised of the thin film layer—that oscillate out-of-plane. The frequency at which the maximum amplitude (or velocity) of vibration is achieved is a resonance frequency, which is used to calculate the Young’s modulus of the thin film layer. The group also developed a special Web-based “MEMS calculator” (
http://www.eeel.nist.gov/812/test-structures/MEMSCalculator.htm) that can be used to determine specific thin film properties from data taken with an optical interferometer.
Knowledge of the Young’s modulus values and the residual strain (using ASTM International Standard E 2245) for thin film layers can lead to calculations of residual stress, which in turn, enable semiconductor manufacturers to develop circuit design strategies, fabrication systems and post-processing methods that could increase fabrication yield by reducing the frequency of failures from electromigration, stress migration and delamination.
Source: National Institute of Standards and Technology
Related stories:
Thin films of silicon nanoparticles roll into flexible nanotubes
By depositing nanoparticles onto a charged surface, researchers at the University of Illinois at Urbana-Champaign have crafted
nanotubes from silicon that are flexible and nearly as soft as rubber.
"Resembling miniature scrolls, the nanotubes could prove useful as catalysts, guided laser cavities and nanorobots," said Sahraoui Chaieb, a professor of mechanical and industrial engineering at Illinois and a researcher at the Beckman Institute for Advanced Science and Technology.
SOPRA licenses ellipsometric porosimetry (EP) technology from IMEC
Leuven, Belgium, June 16, 2004 --- SOPRA has signed an exclusive license agreement on IMEC's patented ellipsometric porosimetry technology. IMEC, Europe's largest independent microelectronics and nanotechnology research center, pioneered ellipsometric porosimetry in the mid 90's and built its own R'nD ellipsometric porosimetry (EP) tool a few years ago. It is now one of the key analysis tools of IMEC’s Advanced Interconnect Solutions R'nD Program. The R'nD EP tool was extensively benchmarked with other porosimetry technologies (e.g. PALS, SAXS, SANS) and excellent agreement was demonstrated. SOPRA will have its first commercial products using EP ready for shipping in Summer 2004.
Survey: 'Tanorexia' common among university students
A new study conducted at a large university finds more than 25 percent of those surveyed reported symptoms of tanning dependence, including symptoms similar to alcohol and drug-addicted individuals. Suggestively, the study also found those with a tanning dependence tend to be more likely to be thin and smoke cigarettes than others. The study by researchers at Fox Chase Cancer Center is published in the September/October issue of the
American Journal of Health Behavior.
World's smallest snake found in Barbados
(PhysOrg.com) -- The world's smallest species of snake, with adults averaging just under four inches in length, has been identified on the Caribbean island of Barbados. The species -- which is as thin as a spaghetti noodle and small enough to rest comfortably on a U.S. quarter --was discovered by Blair Hedges, an evolutionary biologist at Penn State. Hedges and his colleagues also are the discoverers of the world's smallest frog and lizard species, which too were found on Caribbean islands. The most recent discovery will be published on 4 August 2008 in the journal
Zootaxa.
As rates rise, researchers find better way to identify melanoma
University of Rochester Medical Center researchers found a new protein produced excessively in malignant melanoma, a discovery that is particularly relevant as skin cancer rates climb dramatically among young women.
Nuclear stress test can detect more than blockages
A less invasive test commonly used to diagnose coronary disease also may be used to detect one of the leading causes of heart failure, say researchers at the Medical College of Georgia.
Good news for a fast-wrinkling generation: Some anti-aging methods work
Fine wrinkles, deeper creases, saggy areas around the mouth and neck – the sights in the mirror that make baby boomers wince – are not inevitable. They result from a structural breakdown inside the skin that some existing treatments effectively counteract by stimulating the growth of new, youthful collagen, University of Michigan scientists say.
Atomic force microscopy reveals liquids adjust viscosity when confined, shaken
Getting ketchup out of the bottle isn’t always easy. However, shaking the bottle before trying to pour allows the thick, gooey ketchup to flow more freely because it becomes more fluid when agitated. The opposite is not typically true – a liquid such as water does not become a gel when shaken.